高速铁路连续箱型梁桥的动力响应与减振分析

根据列车具体的轴距和轴重,建立了和谐号动车组CRH380AL型列车简化模型;对高速铁路两跨连续梁桥采用多自由度欧拉伯努利梁单元进行主梁的模拟,并将液体黏滞阻尼器模拟为有限元阻尼单元;采用Newmark直接积分方法求解了高速列车作用下的连续梁桥运动方程,数值分析了列车车速以及液体黏滞阻尼器的阻尼系数对于高速铁路连续梁桥振动响应的影响。结果表明:黏滞阻尼器对于桥梁具有明显的减振效果,阻尼力不仅与阻尼系数有关还与列车时速有关;同一黏滞阻尼器条件下,桥梁的最大加速度并不随列车速度的增加而单调增加,而是在某些特定列车车速下桥梁的最大加速度出现了峰值,且随着黏滞阻尼器的阻尼系数增大,桥梁振动响应峰值处的最大加速度减幅不同;同一列车时速的条件下,桥梁的减振效果并不是随着阻尼系数的递增呈正比递增,而是随着阻尼系数的增大,阻尼器的减振效果增幅在减小。     

An improved evaluation of the neutron background in the PandaX-Ⅱ experiment

In dark matter direct detection experiments,neutron is a serious source of background,which can mimic the dark matter-nucleus scattering signals.In this paper,we present an improved evaluation of the neutron background in the PandaX-II dark matter experiment by a novel approach.Instead of fully relying on the Monte Carlo simulation,the overall neutron background is determined from the neutron-induced high energy signals in the data.In addition,the probability of producing a dark-matter-like background per neutron is evaluated with a complete Monte Carlo generator,where the correlated emission of neutron(s)andγ(s)in the(α,n)reactions and spontaneous fissions is taken into consideration.With this method,the neutron backgrounds in the Run 9(26-ton-day)and Run 10(28-ton-day)data sets of PandaX-II are estimated to be(0.66±0.24)and(0.47±0.25)events,respectively.     

人教版高中化学必修教科书的内容呈现方式及特点分析*

高中化学教科书是发展学生化学学科核心素养的重要载体和资源平台。依据《普通高中化学课程标准(2017年版)》编写的人教版普通高中化学必修教科书作为分析文本,着重从栏目系统、图像系统、习题系统角度对其呈现方式进行分析,具体特点表现为:栏目系统强化功能性,图像系统凸显直观性,习题系统体现针对性、情境性、开放性,以期为高中化学教师有效使用教科书、落实化学学科核心素养的培养发挥积极作用。     

染料敏化太阳能电池载流子传输的数值模拟

由于在染料敏化太阳能电池(dye-sensitized solar cell, DSSC)中存在染料弛豫、半导体薄膜中电子与氧化态染料分子发生反应和电子在电解质中与氧化态离子复合等不利反应,利用一个更完善的DSSC载流子传输模型对电池的光电性能进行模拟就显得非常重要。为此,本文基于由多重俘获理论建立的DSSC中的包括电子、染料阳离子、碘化物和三碘化物在内的载流子传输模型,数值模拟得到了不同TiO₂薄膜厚度、不同入射光强度与不同染料分子吸收系数下DSSC的J-V曲线。结果表明,随着TiO₂薄膜厚度的增加,太阳能电池的短路电流密度增大,开路电压减小,光电转换效率先增大后减小。当DSSC的TiO₂薄膜厚度为20 μm时,光电转换效率达到最大值7.41%,同时光电转换效率随入射光强度与染料分子吸收系数的增大均有一定程度提高,其中在吸收系数为4 500 cm^-1时,光电转换效率为6.73%。以上结果可以为改进DSSC的光电性能提供理论指导。     

The unusual tribological behavior of diamond-like carbon films under high vacuum

We fabricate F-doped and F-S-codoped diamond-like carbon (DLC) films using plasma-enhanced chemical vapor deposition system. The hardness, Raman spectra, and high-vacuum tribological behaviors indicate that the films are DLC films. The hardness is close related to the tribological properties of DLC films under high vacuum. The high hardness of DLC films would be helpful for obtaining the long lifetime under high vacuum. The lifetimes of F-S-codoped DLC films are about 120 and 140 seconds, which is attributed to the fast graphitization under high vacuum. The lifetime of F-doped DLC films is prolonged to the value of around 300 and 440 seconds, X-ray photoelectron spectroscopy analysis exhibits the existence of the “adsorption” F, and transmission electron microscopy analysis shows that the “adsorption” F could react with Fe to form layered FeF₂ nanocrystal at the initial sliding, which could be helpful for prolonging the lifetime of F-doped DLC films under high vacuum. This investigation opens a new window to overcome the disadvantage of F, S-doped DLC films under high vacuum.     

Breakthrough of 2- to 3-μm scale U–Pb zircon dating using Cameca IMS-1280HR SIMS

A zircon U–Pb dating method with a high spatial resolution of 2- to 3-μm was successfully implemented by using Cameca IMS-1280HR SIMS in this study. Homemade cathode and modified intermediate pole were used to improve the intrinsic performance of duoplasmatron ion source. An O⁻ primary beam with intensity of approximately 3 μA and stability of 0.68% over 40 minutes was achieved and could be used continuously for more than 240 hours under high current conditions. Under Gaussian illumination mode, a 2- to 3-μm O⁻ primary beam was obtained with an intensity of approximately 200 pA. Four standard zircons, namely, 91500, Temora, Plešovice, and Qinghu, were dated using the 2- to 3-μm high spatial resolution U–Pb isotopic analysis, yielding U–Pb ages consistent with their recommended values, within errors. Our work shows that zircon U–Pb dating with high accuracy and spatial resolution can be achieved, on the basis of a series of duoplasmatron modification and instrumental optimization.     

Improving breakdown strength and energy storage efficiency of poly(vinylidene fluoride-co-chlorotrifluoroethylene) and polyurea blend films by double layer structure design

All-organic composites are widely used in energy storage application due to the high breakdown strength performance, but the improvement of energy storage was limited by the relatively low dielectric constant. Therefore, to satisfy the high demands of dielectric materials, energy storage properties of polymer composites should be further enhanced. In this article, poly(vinylidene fluoride-co-chlorotrifluoroethylene) (P(VDF-CTFE)) and polyurea (PUA), which are known as high dielectric ferroelectric material and linearly high energy storage efficiency material respectively, are composited through double layer (DL) casting method for the first time. The properties of DL structured composite film is contrasted with solution blending structure especially in energy storage efficiency, and the results demonstrate that DL structure design can make great use of advantages of two materials and also can avoid the influence of phase separation between P(VDF-CTFE) and PUA efficiently. Moreover, high breakdown strength (6180 kV/cm) and high energy storage efficiency (77%) of DL composites can be realized simultaneously by incorporating PUA as an insulating layer, and the mechanism is discussed in detail. This work provides an effective route to improve the energy storage properties of polymer dielectric materials and shows great application potential.     

Study of all stages of the Diels–Alder reaction of cyclopentadiene with 2,3-dicyano-1,4-benzoquinone and monoadducts: Kinetics,thermochemistry, and high pressure effect

The kinetic parameters and enthalpies of the Diels–Alder reactions between cyclopentadiene and 2,3-dicyano-1,4-benzoquinone leading to the formation of two different monoadducts and bisadduct were determined. The stability of adducts is compared. Monoadduct appears to be thermodynamically more stable than the bisadduct. Comparison with the other Diels–Alder reactions studied previously allows us to conclude that the heat effects upon formation of the considered Diels–Alder adducts are the lowest in comparison with all the studied dienophiles.     

Molecularly engineering polymeric membranes for H2/CO2 separation at 100–300 °C

Over the last two decades, polymers with superior H₂/CO₂ separation properties at 100–300 °C have gathered significant interest for H₂ purification and CO₂ capture. This timely review presents various strategies adopted to molecularly engineer polymers for this application. We first elucidate the Robeson's upper bound at elevated temperatures for H₂/CO₂ separation and the advantages of high-temperature operation (such as improved solubility selectivity and absence of CO₂ plasticization), compared with conventional membrane gas separations at ~35 °C. Second, we describe commercially relevant membranes for the separation and highlight materials with free volumes tuned to discriminate H₂ and CO₂, including functional polymers (such as polybenzimidazole) and engineered polymers by cross-linking, blending, thermal treatment, thermal rearrangement, and carbonization. Third, we succinctly discuss mixed matrix materials containing size-sieving or H₂-sorptive nanofillers with attractive H₂/CO₂ separation properties.